Is this 3D model free to download?

Yes, Wii Sensor Bar Separate Pieces is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Diode_exe, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Wii Sensor Bar Separate Pieces 3D printable model by Diode_exe

Wii Sensor Bar Separate Pieces

Source: Thingiverse by Diode_exe

The Wii Sensor Bar Separate Pieces is a free printable 3D model from Thingiverse by Diode_exe. Details I couldn't print the original because it's too long for by 200x200 mm printer, so I cut it down to this size. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-10-04 License: CC-BY-SA · commercial OK Category: Toys & Games

Tags: games, nintendo, sensor bar, wii

About this model

Details I couldn't print the original because it's too long for by 200x200 mm printer, so I cut it down to this size. When electronics are installed, the back piece doesn't slide properly, so you will need to just push it on. Depending on how you print it, you can bend the walls to get it in. It holds nicely. You can adjust how far apart the pieces are if necessary for different sensitivity. Needed electronics 1. 6 IR LEDs (940 nm recommended) 2. 2 220 ohm resistors (4 100 ohm works, two in series on each piece) 3. wire (I used 18 gauge) 4. USB cable (optional, I haven't used one yet) that you don't mind cutting the end off of (leave the USB A part so you can connect to the Wii/computer. 5. Heatshrink (optional, but recommended) Tip: Put the LEDs on the outside so you can use it as a guide…

Frequently asked questions

Is this 3D model free to download?: Yes. Wii Sensor Bar Separate Pieces is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Diode_exe.
Who made this model?: Designed by Diode_exe, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.