CFS Bottom Desiccant Container
Source: Thingiverse by MakerXDesigns
The CFS Bottom Desiccant Container is a free printable 3D model from Thingiverse by MakerXDesigns. CFS Floor Desiccant Trays ๐ง The floor of the Creality CFS has a recessed slot with a rib down the middle, and a tray drops in on either side of it. You can download the STL file from the original listing below and print it at home.
About this model
CFS Floor Desiccant Trays ๐ง The floor of the Creality CFS has a recessed slot with a rib down the middle, and a tray drops in on either side of it. These are those two trays, sized to fill that bay and to take loose indicating silica you can see, refill and recharge. Nothing is glued, taped or screwed. There is no hardware anywhere in this model โ the trays sit in the recess under their own weight and lift straight out. ๐ฉ ๐ช๐๐๐ง ๐ ๐๐๐๐ฆ ๐๐ง ๐ช๐ข๐ฅ๐ โธ ๐ง๐ต๐ฒ ๐ฉ๐ฒ๐ป๐๐ฒ๐ฑ ๐๐ฎ๐ฐ๐ฒ ๐๐ ๐ง๐ต๐ฒ ๐ง๐ผ๐ฝ โ Each tray sits with a perforated 102 ร 51.5 mm face pointing up into the filament chamber, flush with the bay floor. That face is the full footprint of the tray, so air meets the beads across the whole bay rather than through a slot at one end. โธ ๐๐ ๐ฅ๐ฒ๐ฝ๐น๐ฎ๐ฐ๐ฒ๐ ๐ง๐ต๐ฒ ๐ฆ๐๐ผ๐ฐ๐ธ ๐๐ผ๐๐ฒ๐ฟ ๐ฃ๐น๐ฎ๐๐ฒ๐ โ The CFS floor is two cavities, each holdโฆ
Frequently asked questions
- Is this 3D model free to download?
- Yes. CFS Bottom Desiccant Container is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by MakerXDesigns.
- Who made this model?
- Designed by MakerXDesigns, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in cfs
