Is this 3D model free to download?

Yes, Atari ST Style Slimline Gotek Case is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by MrClump, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Atari ST Style Slimline Gotek Case 3D printable model by MrClump

Atari ST Style Slimline Gotek Case photo 1

Atari ST Style Slimline Gotek Case photo 2

Atari ST Style Slimline Gotek Case photo 3

Atari ST Style Slimline Gotek Case photo 4

Atari ST Style Slimline Gotek Case

Source: Thingiverse by MrClump

The Atari ST Style Slimline Gotek Case is a free printable 3D model from Thingiverse by MrClump. Uses a DB15 input, so will require a custom soldered cable from the Atari ST's DIN14 floppy port. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-10-05 License: CC-BY-SA · commercial OK 1 makes Category: Gadgets & Electronics

Tags: Atari, ST, Style, Slimline, Gotek, Case

About this model

Uses a DB15 input, so will require a custom soldered cable from the Atari ST's DIN14 floppy port. Powered via a USB-C PD trigger module of the type pictured (set to 5V), it will mostly friction fit, but if you want it very secure then you should remove the rear screw terminals which will allow to use the retainer clip. You could also fit a dumb USB port, but using the trigger module allow you to connect to both a standard USB port and PD enabled port and always get the correct voltage; probably unnecessary but I was being careful. You will also require the following: DB15 Port (I would suggest female) 6 x M3 Brass Threaded Inserts 6 x M3 Screws Gotek (of course!) 128x32 OLED display USB-C PD trigger module of the type pictured Insert the threaded inserts into the front, read and middle rea…

Frequently asked questions

Is this 3D model free to download?: Yes. Atari ST Style Slimline Gotek Case is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by MrClump.
Who made this model?: Designed by MrClump, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.