TP-Link Archer C64 router mount
Source: Cults3D by DimaZako
The TP-Link Archer C64 router mount is a free printable 3D model from Cults3D by DimaZako. Snap-fit mount for the TP-Link Archer C64 router in three versions. You can download the STL file from the original listing below and print it at home.
About this model
Snap-fit mount for the TP-Link Archer C64 router in three versions. All three use the same cradle; only the way it attaches is different. Pick the one you need – every version prints without supports. THE CRADLE (same in all versions) The router tilts in under two front hooks and clicks under two side spring latches. A low rear stop keeps it from sliding back. To release, spread the side latches with your fingers. The rear panel and the rear half of both sides stay open for ports, cables and antennas. A 40 mm window at the front leaves the LEDs visible. Router pocket: 121 x 121.5 mm (router body 120 x 120 x 27.9 mm). VERSION 1 – SCREW MOUNT (wall or ceiling) - Four countersunk holes, 4.5 mm, on a 90 x 90 mm square – for 4 mm countersunk screws. Heads sit flush under the router. - Central w…
Frequently asked questions
- Is this 3D model free to download?
- Yes. TP-Link Archer C64 router mount is free to download from Cults3D. Open it in the free Thinger app, or use the "Download from Cults3D" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Cults3D, not by Thinger. We link you directly to the original listing by DimaZako.
- Who made this model?
- Designed by DimaZako, published on Cults3D. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in роутер
