Airsoft Gas Deringer
Source: Thingiverse by TidBit-01
The Airsoft Gas Deringer is a free printable 3D model from Thingiverse by TidBit-01. This is an airsoft deringer built around a green gas shotgun shell. You can download the STL file from the original listing below and print it at home.
About this model
This is an airsoft deringer built around a green gas shotgun shell. Use 12ga or 20mm airsoft green gas shotgun shells with a side fill port. Look up PPS / SHS types. I purchased a set of 5 for about $50 to make a whole bandolier of 'black powder' airsoft deringers. I made this file quite awhile ago for an event, and I figured that other folks may enjoy them! Instructions: 1. Print one of each piece. 2. Remove support material, ensure that the inner section is free of any debris or rough spots. 3. Insert the firing pin with the rounded end facing into the hole, ensure the groove is aligned with the hole for the trigger. 4. Insert the narrow end of the trigger into the trigger well hole. It should slide into the groove of the firing pin. 5. Insert the trigger pin to hold the trigger and firi…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Airsoft Gas Deringer is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by TidBit-01.
- Who made this model?
- Designed by TidBit-01, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in 12 ga shotgun
