8040 Propeller Optimized for Printing, V1.0
Source: Thingiverse by Landru
The 8040 Propeller Optimized for Printing, V1.0 is a free printable 3D model from Thingiverse by Landru. This is a redesign for an 8040 printable propeller with a 5.5mm (13/64") bore. You can download the STL file from the original listing below and print it at home.
About this model
This is a redesign for an 8040 printable propeller with a 5.5mm (13/64") bore. This prop was designed to keep the minimum cross section above .8mm allowing it to be more easily printed, though at a small efficiency loss. The propeller will require support on one edge, which makes it very easy to remove. I can redesign this for some different center hole diameters if requested, just give me some time as I am pretty busy. Here is a short video with the prop on a motor: I will also be uploading a 5030 prop once it is flight tested. I printed mine on a Fablicator using Kisslicer.
Frequently asked questions
- Is this 3D model free to download?
- Yes. 8040 Propeller Optimized for Printing, V1.0 is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Landru.
- Who made this model?
- Designed by Landru, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in 8040
More from Landru
