Is this 3D model free to download?

Yes, Tasmanian Tiger - Thylacine is free to download from MyMiniFactory. Open it in the free Thinger app, or use the "Download from MyMiniFactory" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by MyMiniFactory. Use the "Download from MyMiniFactory" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Jamie Miller, published on MyMiniFactory. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Tasmanian Tiger - Thylacine 3D printable model by Jamie Miller

Tasmanian Tiger - Thylacine

Source: MyMiniFactory by Jamie Miller

The Tasmanian Tiger - Thylacine is a free printable 3D model from MyMiniFactory by Jamie Miller. da Vinci Exotic Species challenge Design: My object was done with photogrammetry using Agisoft. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from MyMiniFactory

32 saves Source: MyMiniFactory Updated 2026-10-24 License: DOWNLOAD-SHARE-MAINTAIN-LICENSE-CREDIT-REMIX-NONCOMMERCIAL-EXCLU · non-commercial

Tags: animal, australia, tiger, tasmanian, thylacine, extinct

About this model

da Vinci Exotic Species challenge Design: My object was done with photogrammetry using Agisoft. I have included photos showing some of the progress. You will see that on my test print that the ears were cut off because they were to thin. I used Sculptris to thicken the ears so that they would print correctly. After 1 failed print the final print turned out perfect. Printing: I use an old ROBO R1+ printer. I used orange smartbuy PLA filament. I didn't use the heated bed, just painters tape. I found I needed to lower the print into the bed by 1.75mm so that it would sit up straight. You will see in the test print it wouldn't sit up. The nozzle is a 0.6mm with a 0.4mm resolution. I use this setup most of the time in order to cut down print time by more than half of the stock setup of 0.4mm no…

Frequently asked questions

Is this 3D model free to download?: Yes. Tasmanian Tiger - Thylacine is free to download from MyMiniFactory. Open it in the free Thinger app, or use the "Download from MyMiniFactory" link above to open the original listing.
Where is the STL hosted?: The download is hosted by MyMiniFactory, not by Thinger. We link you directly to the original listing by Jamie Miller.
Who made this model?: Designed by Jamie Miller, published on MyMiniFactory. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.