Is this 3D model free to download?

Yes, Wio Tracker L1 Lite, Magsafe/standalone case is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by maschmitt, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Wio Tracker L1 Lite, Magsafe/standalone case 3D printable model by maschmitt

Wio Tracker L1 Lite, Magsafe/standalone case photo 1

Wio Tracker L1 Lite, Magsafe/standalone case photo 2

Wio Tracker L1 Lite, Magsafe/standalone case photo 3

Wio Tracker L1 Lite, Magsafe/standalone case photo 4

Wio Tracker L1 Lite, Magsafe/standalone case

Source: Thingiverse by maschmitt

The Wio Tracker L1 Lite, Magsafe/standalone case is a free printable 3D model from Thingiverse by maschmitt. Full redesign, from sketch, of what was originally posted on social media. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-10-23 License: CC-BY-NC · non-commercial Category: Gadgets & Electronics

Tags: LoRa, meshcore, Meshtastic, seeedstudio, Wio

About this model

Full redesign, from sketch, of what was originally posted on social media. Strong volume reduction! The redesigned case has the charge port in a more charge-porty place, still no cover though. Note, the shadow gap between the case halves is not made to fully close. I use the "no hole" mix for my stationary desktop companion. Bill of materials: * Wio Tracker L1 Lite * Heat-set nuts: 4x M2, 4x M3 * 4x M2x6 screw + washers * 4x M3x6 screw * Lipo battery 40x25 with JST 1.0 connector * A fitting magsafe magnet ring, 58mm external diameter, rounded edges, I used this one: * A few dabs of epoxy glue to properly mess things up Battery held in place with a bit of the Wio's packaging foam. 800 mAh (or was it 850) pictured. Commercial reproduction is not allowed. Don't be that person.

Frequently asked questions

Is this 3D model free to download?: Yes. Wio Tracker L1 Lite, Magsafe/standalone case is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by maschmitt.
Who made this model?: Designed by maschmitt, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.