Rear Vent to 4" Adapter for Anycubic Photon
Source: Thingiverse by DocTanner
The Rear Vent to 4" Adapter for Anycubic Photon is a free printable 3D model from Thingiverse by DocTanner. If you've run your Photon without proper ventilation, you've probably already discovered that it can give off some pretty nasty fumes. You can download the STL file from the original listing below and print it at home.
About this model
If you've run your Photon without proper ventilation, you've probably already discovered that it can give off some pretty nasty fumes. Unfortunately, the built-in filter from the factory just doesn't cut it. This adapter replaces the rear exhaust plate of the Anycubic Photon and allows you to connect the printer directly to a standard 4" ventilation duct. With an inline fan, you can then send the fumes through a proper carbon filter or vent them outside. If you'd like to support me, please consider purchasing this design on Pinshape.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Rear Vent to 4" Adapter for Anycubic Photon is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by DocTanner.
- Who made this model?
- Designed by DocTanner, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Rear
