TRONXY X5 Nozzle Cleaner
Source: Thingiverse by BTNZ
The TRONXY X5 Nozzle Cleaner is a free printable 3D model from Thingiverse by BTNZ. This is a part that is designed to clean a nozzle on the TRONXY X5 after nozzle heating but prior to the print. You can download the STL file from the original listing below and print it at home.
About this model
This is a part that is designed to clean a nozzle on the TRONXY X5 after nozzle heating but prior to the print. It clamps to the front left column. I have also included a screenshot of the actual wire brushes I used in my assembly (I cut it down with hacksaw). You will probably want to redesign part of it to use whatever small wire brushes you can get hold of. Also included is a screenshot of the custom G Code I am using with Slic3r in Repetier (This may well be able to be optimised too) It also uses M5 and M6 cap screws so you will need to drill and tap out the holes to suit. (Initial holes are designed into the print, just need to be cleaned up with drill and tap) If there is sufficient interest I may design and upload a part with a flat face that any small wire brush can be glued to
Frequently asked questions
- Is this 3D model free to download?
- Yes. TRONXY X5 Nozzle Cleaner is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by BTNZ.
- Who made this model?
- Designed by BTNZ, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in TRONXY
