Prusa I3 MK3 LED bar holder
Source: Thingiverse by 3DPRINTINGWORLD
The Prusa I3 MK3 LED bar holder is a free printable 3D model from Thingiverse by 3DPRINTINGWORLD. I made this LED bar holder for my Prusa i3 MK3. You can download the STL file from the original listing below and print it at home.
About this model
I made this LED bar holder for my Prusa i3 MK3. It's the same concept as agniusm's but I made this version so the LED bar snaps on the brackets and then the brackets snap onto the hex holes located in top of the z-axis rod supports holding it more securely. i noticed less glare on the bed when the LED bar is held at an angle so this version mounts the bar at a 20 degree angle. This was designed for the MK3 so I don't know if it will work on the MK2 unless someone confirms it. I printed the brackets out of ABS. Since the brackets are designed to snap in place PLA may or may not work, I would think petg might be a good alternative. I purchased the light here for less than $4.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Prusa I3 MK3 LED bar holder is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by 3DPRINTINGWORLD.
- Who made this model?
- Designed by 3DPRINTINGWORLD, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Prusa
More from 3DPRINTINGWORLD
