Archery Target Pen Holder
Source: Thingiverse by Anders644PI
The Archery Target Pen Holder is a free printable 3D model from Thingiverse by Anders644PI. I wanted to make a fun and creative pen holder, and this is what I came up with. You can download the STL file from the original listing below and print it at home.
About this model
I wanted to make a fun and creative pen holder, and this is what I came up with. A pen holder shaped like an archery target. It works by pressing the pens through the holes in the base, and because it's only one layer thick (.2mm), it flexes and holds tightly around the pens. You assemble it as shown in the gif on the bottom of this page. You do need a small strew and nut to mount the base onto the stand. But you basically screw the base and stand together, then fit together the rings on the base, and set the leg in place, by punching the pin into the hole in the stand. PLEASE NOTE: YOU DO NEED TO STICK IT TO THE TABLE SOMEHOW, TO KEEP IT FROM FALLING OVER. This is just my attempt on this 'technique', so fell free to improve on my design. But I hope you like it. And if you like what you se…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Archery Target Pen Holder is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Anders644PI.
- Who made this model?
- Designed by Anders644PI, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Archery
