Lid for 33 cl can
Source: Thingiverse by GodeVen
The Lid for 33 cl can is a free printable 3D model from Thingiverse by GodeVen. Snap on lid for soda or beer can This lid can be handy if you don’t finish your drink. You can download the STL file from the original listing below and print it at home.
About this model
Snap on lid for soda or beer can This lid can be handy if you don’t finish your drink. It is not completely air and water tight, but it is nice when handling your drink or if you put half a can in the fridge. Do not use infill higher than 10% on PLA. This will keep the lid flexible, so it is easy to get it of the can. There are two versions. One with a small brim for easy opening. It can be printed without support. The lids on the picture are made in red (RFPLCXEU0JB) and neon green (RFPLCXEU0AD) PLA on my DaVinci Jr. The print quality were set to “Normal” without any alterations from the standard (10% infill, 0.3 mm layer height, no support, etc)
Frequently asked questions
- Is this 3D model free to download?
- Yes. Lid for 33 cl can is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by GodeVen.
- Who made this model?
- Designed by GodeVen, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
