Savegrabber - open door without touching the handle, press knobs withoud touching - additional barrier for the coronavirus and other germs
Source: Thingiverse by Coolioiglesias
The Savegrabber - open door without touching the handle, press knobs withoud touching - additional barrier for the coronavirus and other germs is a free printable 3D model from Thingiverse by Coolioiglesias. Hi, this is my attempt to hopefully reduce the spread of the coronavirus or other germs, I call it the "Savegrabber". You can download the STL file from the original listing below and print it at home.
About this model
Hi, this is my attempt to hopefully reduce the spread of the coronavirus or other germs, I call it the "Savegrabber". It is a hook-like device that allows the opening and closing of doors without touching the handle. There is also a tip to press buttons in the elevator or light switches. The touching surfaces are designed to be as small as possible, so the contamination should be low. My idea is to wear the Savegrabber with a retractable key chain on the belt or on a bag. If everyone would use this, I think this could be an additional barrier to germs. The print in PLA is sufficient and you can clean it using alcoholic disinfect. So please print as much as you can and give it to others. If you have ideas to optimize - please do so. The Savegrabber has been designed in Fusion360. I produced…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Savegrabber - open door without touching the handle, press knobs withoud touching - additional barrier for the coronavirus and other germs is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Coolioiglesias.
- Who made this model?
- Designed by Coolioiglesias, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Savegrabber
