Kitchen Sink Caddy/Tray
Source: Thingiverse by rbrome
The Kitchen Sink Caddy/Tray is a free printable 3D model from Thingiverse by rbrome. This is a tray/caddy to hold wet things (sponge, brush, soap) that might stain your countertop, etc. You can download the STL file from the original listing below and print it at home.
About this model
This is a tray/caddy to hold wet things (sponge, brush, soap) that might stain your countertop, etc. It's designed to hang over the edge of your sink, with a sharp drip edge. The raised ridges are flat, while the grooves in-between are angled to promote quick drainage. Those parts have rounded corners to make it easier to clean. Grooves on the underside promote airflow to dry out any water that might get underneath. A beveled back edge allows it go against a wall and fit around any caulk, etc. while also promoting airflow underneath. Even with the un-conventional bottom surface, it should print as-is, upright, with no support. As the "grooves" on top have a very gentle slope, I recommend the smallest layer height you can manage, as this aspect of the design makes layers very obvious. I pri…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Kitchen Sink Caddy/Tray is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by rbrome.
- Who made this model?
- Designed by rbrome, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Kitchen
