240mm by 15mm Fan Spacer, Split
Source: Thingiverse by Pants536
The 240mm by 15mm Fan Spacer, Split is a free printable 3D model from Thingiverse by Pants536. Expanded the depth to 15mm, which I needed to go from the bottom of an NR200 to 2x120mm fans pushing it right up against my specific deshrouded GPU (Asus 5700xt TUF). You can download the STL file from the original listing below and print it at home.
About this model
Expanded the depth to 15mm, which I needed to go from the bottom of an NR200 to 2x120mm fans pushing it right up against my specific deshrouded GPU (Asus 5700xt TUF). Print two of these, and they will slot together. It's very tight, I had to use a rubber mallet to get them 90% of the way, and then a hammer with one good smack to make them flush. The holes will line up with 2x120mm fans right next to each other. There is enough room between the top and bottom screw holes to fit a fan screw, and you can screw them into the fans through the hole on other side. The holes are a touch big, so either fill them in a bit or find a good fan screw that can thread them and hold. I had some that worked so I didn't shrink the hole.
Frequently asked questions
- Is this 3D model free to download?
- Yes. 240mm by 15mm Fan Spacer, Split is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Pants536.
- Who made this model?
- Designed by Pants536, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in 240mm
