Acrobrat - 20x20 Capacitor Mount
Source: Thingiverse by TheDronanaut
The Acrobrat - 20x20 Capacitor Mount is a free printable 3D model from Thingiverse by TheDronanaut. This is the Capacitator mount I designed when building my Acrobrat. You can download the STL file from the original listing below and print it at home.
About this model
This is the Capacitator mount I designed when building my Acrobrat. The sleeve dimensions are 10MM dia x 16MM length. It was designed around this cap from RDQ: I used 10-12MM M2 button head screws for the stack mount. Just check your stack accordingly as these will add 3MM. Also, I nipped out little "notches" from the bottom side of the mount. Only where I needed to solder wires. It was a pretty tight fit with the flight controller I used. * Print with .2MM line height. * Print with Support material. Finally, check out my other Acrobrat parts! HATCHBACK MOUNT (XT60, AXII, IMMORTAL T) BEEPER MOUNT My Acrobrat Flight Footage: Enjoy!
Frequently asked questions
- Is this 3D model free to download?
- Yes. Acrobrat - 20x20 Capacitor Mount is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by TheDronanaut.
- Who made this model?
- Designed by TheDronanaut, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
