Anet A8 Hold Down Bracket
Source: Thingiverse by freemark
The Anet A8 Hold Down Bracket is a free printable 3D model from Thingiverse by freemark. These are mounting bracket for Anet A8 and A6 printers. You can download the STL file from the original listing below and print it at home.
About this model
These are mounting bracket for Anet A8 and A6 printers. Their purpose is to hold down and stabilize the printer base so it doesn't flex while printing or come out of alignment when moved. Print four brackets, one to hold down each end of the threaded rods as shown in photo. IMPORTANT: To work correctly the brackets need to hold the printer tightly to the mounting surface, so be sure to put a small piece of duct tape on the inside of the bracket to provide a tighter grip against the threaded rods and prevent slipping. For best results the printer should be mounted to a rigid stable surface. A sheet of 3/4 inch or 19mm particle board, mdf or plywood should work well. Be sure to use a good quality material, especially for plywood, so it doesn't warp. If you don't need portability you can moun…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Anet A8 Hold Down Bracket is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by freemark.
- Who made this model?
- Designed by freemark, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Anet
