2000-2007 Mitsubishi Lancer 2.0L Cold Air Intake (Non-Evo)
Source: Thingiverse by garagesteve
The 2000-2007 Mitsubishi Lancer 2.0L Cold Air Intake (Non-Evo) is a free printable 3D model from Thingiverse by garagesteve. YOU MUST PRINT WITH PETG OR SOMETHING THAT CAN HANDLE HEAT AS WELL OR BETTER THAN PETG!!!!!!!!!!!!!! The battery must be moved to the trunk to make room for the pipe to go down. You can download the STL file from the original listing below and print it at home.
About this model
YOU MUST PRINT WITH PETG OR SOMETHING THAT CAN HANDLE HEAT AS WELL OR BETTER THAN PETG!!!!!!!!!!!!!! The battery must be moved to the trunk to make room for the pipe to go down into the bumper on this particular car. I also had to use a grinder to make the hole big enough, but that was most likely only specific to this vehicle. I only cut into non-structural sheet metal. It is easy to figure out where to cut once you have the headlight off. You will need to buy two 3" rubber couplers and a cone filter with a 3" opening. You will also need to buy 4 bolts & locking nuts, and a piece of flat aluminum bar from Home Depot or Lowes to create the metal support piece that connects to the MAF adapter down to the old air filter box mount. The printed coupler will be JB Welded on to the straight side…
Frequently asked questions
- Is this 3D model free to download?
- Yes. 2000-2007 Mitsubishi Lancer 2.0L Cold Air Intake (Non-Evo) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by garagesteve.
- Who made this model?
- Designed by garagesteve, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
