Is this 3D model free to download?

Yes, ESP32 WLED Sound Reactive Box is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by jgutz20, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

ESP32 WLED Sound Reactive Box 3D printable model by jgutz20

ESP32 WLED Sound Reactive Box

Source: Thingiverse by jgutz20

The ESP32 WLED Sound Reactive Box is a free printable 3D model from Thingiverse by jgutz20. I've seen quite a few ESP32 boxes out there, and even some that can accommodate a speaker for running WLED SR (Sound Reactive), but i wanted a box with a little bit more room. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

48 saves Source: Thingiverse Updated 2026-10-05 License: CC-BY-NC-SA · non-commercial Category: Gadgets & Electronics

Tags: Aircookie, electronics box, electronics case, electronics enclosure, enclosure, esp32, ESP 32, mount, nodemcu, reactive, sound, sound reactive, WLED, WLED SR

About this model

I've seen quite a few ESP32 boxes out there, and even some that can accommodate a speaker for running WLED SR (Sound Reactive), but i wanted a box with a little bit more room. I made this container/enclosure for those that want a little bit more room for using breadboard jumpers instead of soldering your pins and just extra space for longer wires etc. It is 58.5mm wide x 83mm long and 52mm tall (54.5mm with lid), The 4 standoffs for mounting your ESP-32 board are 35mm tall (1 ⅜ inches) giving you plenty of room for your breadboard jumpers, on top of the standoffs are pins that align and allow your ESP32 to “snap” into place. I adjusted this until it was easy to set the chip in, while still doing a good job of holding the dev board in place. On one of the sides, i made a little cradle to fi…

Frequently asked questions

Is this 3D model free to download?: Yes. ESP32 WLED Sound Reactive Box is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by jgutz20.
Who made this model?: Designed by jgutz20, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.