Auduino Uno Granular Synth Case
Source: Thingiverse by Svargon
The Auduino Uno Granular Synth Case is a free printable 3D model from Thingiverse by Svargon. Here is a case and knobs needed to construct a simple granular synthesizer. You can download the STL file from the original listing below and print it at home.
About this model
Here is a case and knobs needed to construct a simple granular synthesizer. I like to make this a permanent instrument so I solder the wires to the Adruino Uno. This project was inspired by this link so look here for wiring and programming details: I print my cases with PLA plastic. For the top piece, in Cura, I set the support Line Distance to 10 mm to save plastic. I like 20% Infill. The knobs I print are printed in TPU plastic and don't need a set screw for them to fit tight. PLA knobs are a tight fit. I may revisit the knobs in the future. Apart from the case for parts you need: 1 - Arduino UNO R3 CH340, the ones with holes to solder 5 - 4.7K (or 5K) - Linear taper potentiometers 4 - Short 1/2" #6 screws to hold the bottom on. 4 - Tiny screws - to secure the board. I don't know, I pull…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Auduino Uno Granular Synth Case is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Svargon.
- Who made this model?
- Designed by Svargon, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Auduino
