Nalgene Bottle Clip
Source: Thingiverse by UptonAK
The Nalgene Bottle Clip is a free printable 3D model from Thingiverse by UptonAK. Ever go to take a drink and get splashed from the water in the cap of your nalgene? Maybe you have adopted the "one finger hold down" grasp as you drink. You can download the STL file from the original listing below and print it at home.
About this model
Ever go to take a drink and get splashed from the water in the cap of your nalgene? Maybe you have adopted the "one finger hold down" grasp as you drink. This little print keeps the lid down allowing you turn your bottle into a more normal drinkware container. I find I drink more water throughout the day if the cap is back and the bottle is more like a big cup. Ive had this on two of my bottles for over a year, out in the woods, hiking, drops, freezing and it has held up just fine. After printing cut a small strip of 3M outdoor mounting tape and stick it on the back. I find its easier to stick the part onto the roll and then cut along the bottom edge of the part. If you are printing the non raft version and add your own raft, your slicer may fill in the hard to clean out area inside the cl…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Nalgene Bottle Clip is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by UptonAK.
- Who made this model?
- Designed by UptonAK, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Nalgene
