Stop for Festool FS track
Source: Thingiverse by Enrico74
The Stop for Festool FS track is a free printable 3D model from Thingiverse by Enrico74. This is a stop block that fits a Festool track. You can download the STL file from the original listing below and print it at home.
About this model
This is a stop block that fits a Festool track. It is designed to set starting and stopping points for a track saw. An M6x12 bolt is used to tighten the block with a corresponding M6 nut trapped in a plastic adapter that goes into the aluminum extrusion. A knob (made with the brilliant nut knob generator: grabs the hex head of the M6 bolt, making it easy to secure and release the block. A washer can be added to serve as a spring, between the knob and the block, but this is not mandatory. The block has a round notch that catches the corner of the base of the saw so there are two models: a start/front block and a stop/rear block. Typically print one of each block and two knobs plus two nuts. 2017-05-16: Added a start-front symetrical version of the stop as requested ;)
Frequently asked questions
- Is this 3D model free to download?
- Yes. Stop for Festool FS track is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Enrico74.
- Who made this model?
- Designed by Enrico74, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Stop
