Glow in the dark Auto-recharge circuit (Photocell not timer)
Source: Thingiverse by jpasternack
The Glow in the dark Auto-recharge circuit (Photocell not timer) is a free printable 3D model from Thingiverse by jpasternack. Glow in the dark Auto-recharge circuit using an Photocell(light sensor) and UV LED's to flash charge the filament. You can download the STL file from the original listing below and print it at home.
About this model
Glow in the dark Auto-recharge circuit using an Photocell(light sensor) and UV LED's to flash charge the filament. - I only have it flash for a second so it will dim quick and you can see it work. The INO files are also in the thing files. Put inside the model or behind, it works off a photocell, so it only flashes on for a few seconds once the photocell registers the glow dimming. ALL INFO TO MAKE BELOW, I AM SORRY TO ALL THAT COULDN'T WAIT THE 5MIN FOR ME FINISH THE SIMPLE SCHEMATIC, OR THE TYPO WAS THAT IMPORTANT TO GIVE ME A HARD TIME ABOUT. SORY I AMM HUMAAN AL-SO. Code: int ledPin = 13; // the pin you wish to control the led int turnON = 990; // the dim value that will switch the charge light back on (This will change depending on where you put the photocell on the model, I made the …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Glow in the dark Auto-recharge circuit (Photocell not timer) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by jpasternack.
- Who made this model?
- Designed by jpasternack, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
