Anycubic i3 Mega Spool Holder for Direct Drive
Source: Thingiverse by art_fpv
The Anycubic i3 Mega Spool Holder for Direct Drive is a free printable 3D model from Thingiverse by art_fpv. After upgrading to Hemera I needed a different spool holder that would work with Direct Drive extruder. You can download the STL file from the original listing below and print it at home.
About this model
After upgrading to Hemera I needed a different spool holder that would work with Direct Drive extruder. I fancied the Prusa holders since they simply looked best and decided to remix one done by Mirkoengineer to fit i3 Mega top frame. I had to print few test prints to make sure it fits to the frame. It's pretty easy to put it on and remove if required. Hope you like it. Make sure you use few bottom laters for support. I didn't do it on mine and just before it was printing the tiny L shape bit at the end of holder arm my whole support fell off :) I had to reprint just that section and hot glue it in place.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Anycubic i3 Mega Spool Holder for Direct Drive is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by art_fpv.
- Who made this model?
- Designed by art_fpv, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Anycubic
