Creality CR-6 SE Optical Filament Sensor Inline Case
Source: Thingiverse by vampyrex13
The Creality CR-6 SE Optical Filament Sensor Inline Case is a free printable 3D model from Thingiverse by vampyrex13. This will allow you to add PC4-M10 couplers to the ends of the Creality CR-6 SE optical sensor so it can be used inline. You can download the STL file from the original listing below and print it at home.
About this model
This will allow you to add PC4-M10 couplers to the ends of the Creality CR-6 SE optical sensor so it can be used inline. In my case, I'm using it with my direct drive Ender 6 as it was easier to load and more reliable than the previous two sensors I was using. More Ender 6 models at Klipper Firmware Notes ---------------------- Unlike the factory runout sensor, this one uses an inverted pin. Just add a ! in front of PA4. [filament_switch_sensor e0_sensor] switch_pin: !PA4 Hardware ------------- • (2) M3x20mm socket cap screws • (2) PC4-M10 push fittings Installation Notes ------------------ • Bevel the inside of the outlet PTFE tube to make loading filament easier. Parts ----- Below is my list of parts I used (affiliate links). • CR-6 SE Runout Sensor : • PC4-M10 Push Fitting: Buy Me a Cof…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Creality CR-6 SE Optical Filament Sensor Inline Case is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by vampyrex13.
- Who made this model?
- Designed by vampyrex13, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Creality
