LiPo charging case
Source: Thingiverse by toonjanssens
The LiPo charging case is a free printable 3D model from Thingiverse by toonjanssens. Charging case to charge up to 4 batteries at the same time. You can download the STL file from the original listing below and print it at home.
About this model
Charging case to charge up to 4 batteries at the same time. Power source Three options to power the case - Main power - XT-60 (7 - 28V DC) - Banana plug (7 - 28V DC) 24V PSU I've put 2 server PSU's 460W each in the bottom of the case and connected them in serie. ATTENTION!! you need to isolate the second PSU from the ground to prevent a short circuit! You can also use 12v, but then you can not utilise the full potential of the chargers and the current in the wires will be greater. Internal battery I did not include an internal battery because I already own some bigger LiPo batteries and I can easily plug those in. There is not a lot of space left in the case, so it would be difficult to fit it in. Cooling 2 fans for cooling are powered by a DC/DC converter connected to the left charger inp…
Frequently asked questions
- Is this 3D model free to download?
- Yes. LiPo charging case is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by toonjanssens.
- Who made this model?
- Designed by toonjanssens, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in LiPo
