Projector tilting mount
Source: Thingiverse by mrgizmo9999
The Projector tilting mount is a free printable 3D model from Thingiverse by mrgizmo9999. This was made to mount a small projector on the ceiling of an RV. You can download the STL file from the original listing below and print it at home.
About this model
This was made to mount a small projector on the ceiling of an RV. Hardware list: Qty 2 bolts. 1/4-20 x 1-1/2" long. 7/16" hex head. Qty 1, 1/4" flat washer. Place the washer between the mount body and the knob to reduce friction while tightening. Use 1 bolt to thread into the round projector mounting surface. It should be a tight fit and thread all the way inside. Then cut off the head of the bolt, leaving about 3/16" exposed. You will need to carefully clean the end of the threads where they were cut. The 2nd bolt holds the parts together and threads into the knob. The photo shows the mount before I added the mounting holes. I was going to use double sided tape. Could also be used as a camera mount. Updated 9/20/18 I've added some additional mounts for a 1" square bar. The square bar slid…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Projector tilting mount is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by mrgizmo9999.
- Who made this model?
- Designed by mrgizmo9999, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Adjustable
