Ender 3 v2 neo auto poweroff switch
Source: Thingiverse by Pivoine311
The Ender 3 v2 neo auto poweroff switch is a free printable 3D model from Thingiverse by Pivoine311. Modification of the E3V2 design to fit specifically the Ender 3 V2 Neo Recommendations: a) Connecting the autostop switch in parallel of the printer switch (i.e. You can download the STL file from the original listing below and print it at home.
About this model
Modification of the E3V2 design to fit specifically the Ender 3 V2 Neo Recommendations: a) Connecting the autostop switch in parallel of the printer switch (i.e. connecting both switch pin to pin), and not serially (as suggested in the original post), greatly simplifies the usage : - By powering via the rear switch, the auto-shut is disabled - By powering via the front switch, the auto-shut is enabled b) Use a cable of the same diameter as the ones in the printer to avoid any power / overheating problem c) Print the model in the provided orientation with tree support touching buildplate 80% overhang angle (other parameters as you wish) Here is the End G-code I'm using : G91 ;Relative positionning G1 E-2 F2700 ;Retract a bit G1 E-2 Z0.2 F2400 ;Retract and raise Z G1 X5 Y5 F3000 ;Wipe out G1…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Ender 3 v2 neo auto poweroff switch is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Pivoine311.
- Who made this model?
- Designed by Pivoine311, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Ender
