Induction Heater IHMiniBat for Dynavap
Source: Thingiverse by Zaar137
The Induction Heater IHMiniBat for Dynavap is a free printable 3D model from Thingiverse by Zaar137. Induction Heater IH-MiniBat Video demo: I designed this IH with the right measurements for the Mini ZVS 12v board, the Mosfet and a 3s 2200mah battery. You can download the STL file from the original listing below and print it at home.
About this model
Induction Heater IH-MiniBat Video demo: I designed this IH with the right measurements for the Mini ZVS 12v board, the Mosfet and a 3s 2200mah battery. It has a switch to activate the internal battery or external input. The internal battery can be charged while using the internal or external battery. The measurements of the IH-MiniBat are 126x85x35mm and a 3s battery of up to 100x34x28mm can be inserted (minimum 30c discharge). For it to work with an external battery, a minimum of 6 amps of discharge and a maximum of 12.6v are needed, if you put more voltage it will burn. The Mini ZVS board has been modified by changing the 2 induction coils for two smaller ones and removing a capacitor, the other must be changed to the opposite side. The heating coil must be soldered to the board, do not …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Induction Heater IHMiniBat for Dynavap is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Zaar137.
- Who made this model?
- Designed by Zaar137, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
