OpenRC F1 Internal gear box mod
Source: Thingiverse by intoxikated
The OpenRC F1 Internal gear box mod is a free printable 3D model from Thingiverse by intoxikated. !!!WARNING!!! This is an untested mod! This mod is to bring the gear ratio down a bit and to put all the moving parts inside of the RC body to protect the gears. You can download the STL file from the original listing below and print it at home.
About this model
!!!WARNING!!! This is an untested mod! This mod is to bring the gear ratio down a bit and to put all the moving parts inside of the RC body to protect the gears. All parts on the list are replacements to originals. Reused unmodified parts: rear_wheel_axle Wheel_axle_holder_left* rear_wing rainlight_and_diffuser *Mirror for right side Parts required: 2 18x12x4 bearings various m3 and m4 screws and nuts, I have not determined what lengths yet Same motor and electronics are used. Body parts will need to be printed with supports!!! Bes sure to follow this as it is an ongoing project!!!
Frequently asked questions
- Is this 3D model free to download?
- Yes. OpenRC F1 Internal gear box mod is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by intoxikated.
- Who made this model?
- Designed by intoxikated, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in OpenRC
