Cycloidal Reducer, 2 Cycloids- 10:1
Source: Thingiverse by Ozan2009
The Cycloidal Reducer, 2 Cycloids- 10:1 is a free printable 3D model from Thingiverse by Ozan2009. Made to Mount of Nema 17 with a reduction ratio of 10:1. You can download the STL file from the original listing below and print it at home.
About this model
Made to Mount of Nema 17 with a reduction ratio of 10:1. Designed to be low friction. Requires: - 4 x m3 screws for mounting on the motor - 11 x m6*20 to mount the top half of the casing to the bottom - 22 x HK0608 needle bearings - 2 x 6000rs bearings - 1 x 51107 thrust bearing I printed with PC at 50% infill for most of this print which I think was overkill. Should get away with printing with almost any filament at much lower infill since there isn't much friction anyway. I used a Creality K1C and have designed with 0.1-0.2mm tolerances depending on the parts.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Cycloidal Reducer, 2 Cycloids- 10:1 is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Ozan2009.
- Who made this model?
- Designed by Ozan2009, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in cycloid
