Is this 3D model free to download?

Yes, 2020 Enclosure Clip with Screw Hole is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Afrobaron, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

2020 Enclosure Clip with Screw Hole 3D printable model by Afrobaron

2020 Enclosure Clip with Screw Hole photo 1

2020 Enclosure Clip with Screw Hole

Source: Thingiverse by Afrobaron

The 2020 Enclosure Clip with Screw Hole is a free printable 3D model from Thingiverse by Afrobaron. These are some clips I designed to allow foam board to be mounted cleanly to the FT-5 printer. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

115 saves Source: Thingiverse Updated 2026-10-31 License: CC-BY · commercial OK 1 makes Category: 3D Printer

Tags: 2020, enclosure, foamboard

About this model

These are some clips I designed to allow foam board to be mounted cleanly to the FT-5 printer. The clip will squeeze the foam board up against an outer bracket. I also added screw holes so you can put them in and hold a panel in place where it might need a little extra support. I used screws to hold down my top as my cables tend to push on the foam a bit. Print laying on the side and you shouldn't need supports. Just multiply the model to give you the number you need.

Frequently asked questions

Is this 3D model free to download?: Yes. 2020 Enclosure Clip with Screw Hole is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Afrobaron.
Who made this model?: Designed by Afrobaron, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.