Anet A8 bed level calibration test
Source: Thingiverse by NeoCortex
The Anet A8 bed level calibration test is a free printable 3D model from Thingiverse by NeoCortex. This is the test I came up with for my Anet A8 bed level. You can download the STL file from the original listing below and print it at home.
About this model
This is the test I came up with for my Anet A8 bed level. It goes all around the bed 2 times and prints 2 10x10x5mm cubes in the center. It prints 2 lines right next to each other. If your bed level is on point, you can see a small gap between them. (picture 1) If it's to low it presses the lines into each other. (just a bit is fine - picture 2) If it's to high, you will see the filament not sticking to the bed. No brim, raft, rift! No infill! Turned out to be a pretty good testing methode.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Anet A8 bed level calibration test is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by NeoCortex.
- Who made this model?
- Designed by NeoCortex, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Anet
