Buster sword bookmark
Source: Thingiverse by matiesout
The Buster sword bookmark is a free printable 3D model from Thingiverse by matiesout. Found a sword shaped bookmark (by mdraz1997 check it out) and thought about what other swords were iconic enough to use for this purpose. You can download the STL file from the original listing below and print it at home.
About this model
Found a sword shaped bookmark (by mdraz1997 check it out) and thought about what other swords were iconic enough to use for this purpose. The result is right here. I used the Buster Sword by MoustachePolice as a base for this bookmark. I flattened and elongated the blade to make it work as a bookmark. Then I split the sword in half so it prints flat without supports. Middle piece should be flexible enough to wrap around a page in your favorite Final Fantasy novel so you never lose track of your progress. It's quite big but it prints in about 45 minutes at 0.2mm layer height. NOTE: Don't push down too hard on the bookmark, it might damage your book because of the sharp edges. Printing: Printed at 0.2mm layer height 2 walls, 4 top 4 bottom 20% infill
Frequently asked questions
- Is this 3D model free to download?
- Yes. Buster sword bookmark is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by matiesout.
- Who made this model?
- Designed by matiesout, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
