Flexing battery holders with 2- and 3-cell compartments
Source: Thingiverse by enif
The Flexing battery holders with 2- and 3-cell compartments is a free printable 3D model from Thingiverse by enif. Thingiverse user pcoulbourne asked me if I could extend my flexing battery holders with integrated spring project to also support multi-cell compartments which house 2 or 3 cells. You can download the STL file from the original listing below and print it at home.
About this model
Thingiverse user pcoulbourne asked me if I could extend my flexing battery holders with integrated spring project to also support multi-cell compartments which house 2 or 3 cells in series and are held with a single plastic spring. With more than one cell in a row the pushing force of the spring is prone to lift the batteries up at their joining point and push them out of the compartment. Also longer cells are more prone to cause warping. The solution to these problems was to add cutouts at the center of each cell to allow a better grip when manipulating the cells (and thereby reducing the warping!) and add an inside overhang between the cutouts to prevent the batteries from popping out. The included fully parametrized SCAD file is an extension to the initial version, thus it can as well b…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Flexing battery holders with 2- and 3-cell compartments is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by enif.
- Who made this model?
- Designed by enif, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Flexing
