CALIBLOCK - Calibration Print Toy
Source: Thingiverse by tempo502
The CALIBLOCK - Calibration Print Toy is a free printable 3D model from Thingiverse by tempo502. This is the CaliBlock (calibration + block). You can download the STL file from the original listing below and print it at home.
About this model
This is the CaliBlock (calibration + block). It's a calibration print that can be also used as a nifty building toy. If your printer is reasonably well-calibrated, CaliBlocks will snap together much like Legos. No pins or screws required. TAKE THE 1 HOUR CALIBLOCK CHALLENGE! Try to print a "caliblock normal half" in less than one hour. It's a challenge for most printers! You must meet the following conditions: - Be honest! Nobody likes cheaters. - Actual recorded print time must be less than 1 hour, slicer estimates don't count. - No scaling, final dimensions must be +/-1% of the targets. - 1-hour CaliBlocks must clip and unclip with other CaliBlock without breaking. - Post a close-up "make" photo of the print along with your printer model and slicer settings to prove you did it. If you su…
Frequently asked questions
- Is this 3D model free to download?
- Yes. CALIBLOCK - Calibration Print Toy is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by tempo502.
- Who made this model?
- Designed by tempo502, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in CALIBLOCK
