Is this 3D model free to download?

Yes, Door Holder (Ball and Socket) is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by dougeefresh, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Door Holder (Ball and Socket) 3D printable model by dougeefresh

Door Holder (Ball and Socket)

Source: Thingiverse by dougeefresh

The Door Holder (Ball and Socket) is a free printable 3D model from Thingiverse by dougeefresh. No latch. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

2,061 saves Source: Thingiverse Updated 2026-10-09 License: CC-BY · commercial OK Category: Tools & Workshop

Tags: ball, Ball and Socket, ball joint, door, doorstop, door holder, door hook, hodor, holder, indoor garden, outdoor, socket

About this model

No latch. No slide. No hook. Just push to engage and pull to disengage! Door holder to keep your door open (or HODOR!) when the door holder is pushed in. If using PETG (Recommended) ========================= - Use the standard version STL (Door-Holder-Socket.STL). The standard version printed using PLA will likely snap. See below if using PLA. - Use high infill (80% or higher) since it will likely be exposed to abuse. - Use the typical settings to increase strength (higher temp, low/no fan, etc.) - You can probably print this in ASA or Nylon (not tested) - The ball part is the same for both PETG and PLA. UPDATED (10/3/2021) - Recommended infill to 80%. - Thicker flaps in the middle (~30% increase) for added strength. - Wider opening (~0.8mm) to lessen stress put on the flaps. If using PLA …

Frequently asked questions

Is this 3D model free to download?: Yes. Door Holder (Ball and Socket) is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by dougeefresh.
Who made this model?: Designed by dougeefresh, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.