Anycubic Kossel Linear Plus Magnet Upgrade
Source: Thingiverse by Atziano
The Anycubic Kossel Linear Plus Magnet Upgrade is a free printable 3D model from Thingiverse by Atziano. This parts are used to convert an Anycubic Kossel Linear Plus to magnetic delta arms. You can download the STL file from the original listing below and print it at home.
About this model
This parts are used to convert an Anycubic Kossel Linear Plus to magnetic delta arms. These are designed so that the original hotend can be used. The original geometry of the printer stays nearly the same (rod lengh 267mm). The magnets I've used are magnetized according to the manufacturer with n40 and have a holding power of about 5 kilograms. But this probably applies to smooth metal surfaces. With the steel ball used, the tightening force will be lower, but enough to keep the effector. The magnets I glued with 2k glue in the carriage and in the effector. 4x20mm threaded rods are screwed into the steel balls and then glued into the carbon rods. Important here is the exact same length of the rods. Measured on the outside of the steel balls, they should be exactly 277mm long, since the piv…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Anycubic Kossel Linear Plus Magnet Upgrade is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Atziano.
- Who made this model?
- Designed by Atziano, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Anycubic
