Flashlight Shoulder Mount (Emisar D4v2)
Source: Thingiverse by attackhorse
The Flashlight Shoulder Mount (Emisar D4v2) is a free printable 3D model from Thingiverse by attackhorse. This is a flashlight mount for various types of shoulder straps to allow for handsfree use. You can download the STL file from the original listing below and print it at home.
About this model
This is a flashlight mount for various types of shoulder straps to allow for handsfree use. It has been specifically designed to house an Emisar D4 and Emisar D4v2 flashlight (sans pocket clip) but can accommodate any flashlight with a cylindrical portion 25 mm or smaller in diameter and 51 mm or larger in length. The mount works best with shoulder straps approximately 46 mm wide and 2 mm thick, though there is a bunch of wiggle room. When used with an Emisar D4, this mount allows for full access to the switch and battery compartment without having to remove the flashlight from the mount. There is also minimal to no contact with the head of the flashlight to allow for maximum airflow. You will need the following hardware for this build: 6 binding barrels and screws for ¼” thick material 6 …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Flashlight Shoulder Mount (Emisar D4v2) is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by attackhorse.
- Who made this model?
- Designed by attackhorse, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Flashlight
