BIG Hot Glue Gun Stand / Holder
Source: MakerWorld by UoAoE3D
The BIG Hot Glue Gun Stand / Holder is a free printable 3D model from MakerWorld by UoAoE3D. The design done by Heerozh was good for what I needed; however, my glue gun is thinner than what the actual holder designed in the model, so the gun was swinging all over the. You can download the STL file from the original listing below and print it at home.
About this model
The design done by Heerozh was good for what I needed; however, my glue gun is thinner than what the actual holder designed in the model, so the gun was swinging all over the place.I made a small modification where I added 2 pieces of TPU 95 to the side of the holder to hold the gun in place, will it turned out to be the best upgrade possible for this gun stand/holder. Now I can just lay the gun down (I don’t even have to push it in) and it will hold in place. It will always be held perfectly and most important more safely.The original design holder ID spacing is 40mm wide, the glue gun I have is 29mm wide, each piece of the TPU is about 6mm think, that made thing just tight enough to hold the gun in place.I do think any glue gun with width of 27mm to 31mm will benefit from this (when usin…
Frequently asked questions
- Is this 3D model free to download?
- Yes. BIG Hot Glue Gun Stand / Holder is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by UoAoE3D.
- Who made this model?
- Designed by UoAoE3D, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in holder
