Millennium Falcon Christmas Tree Topper
Source: MakerWorld by ASTDrones
The Millennium Falcon Christmas Tree Topper is a free printable 3D model from MakerWorld by ASTDrones. This is a remix of two models to make Millennium Falcon Christmas Tree Topper with an EL wire light up engine. I used OnShape and Meshmixer to design the parts i needed to add. You can download the STL file from the original listing below and print it at home.
About this model
This is a remix of two models to make Millennium Falcon Christmas Tree Topper with an EL wire light up engine. I used OnShape and Meshmixer to design the parts i needed to add and subtract to the existing ones. The tree topper cone had holes to add zip ties to hold it more securely to the tree top. I printed with 10% infill, 2 walls, 0.2mm layer height and no supports in Black PLA. I then spray painted it white and add some weathering with black and brown acrylic paint. I then went over with some of my kids red, orange and blue makers for some extra pop. I used this Ice Blue EL wire i found on AliExpress for a few dollars.AssemblyInsert EL wire from inside the back half through the holes, then run it to the other side, loop it around and go back, I ended up doing 3 Lines of EL wire in the …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Millennium Falcon Christmas Tree Topper is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by ASTDrones.
- Who made this model?
- Designed by ASTDrones, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in star wars
