Rear Pi mount for Anet A8
Source: Thingiverse by Chir
The Rear Pi mount for Anet A8 is a free printable 3D model from Thingiverse by Chir. I remixed the Anet A8 LCD backplate with a fantastic Raspberry Pi case. You can download the STL file from the original listing below and print it at home.
About this model
I remixed the Anet A8 LCD backplate with a fantastic Raspberry Pi case. My goal was to move the Pi to the back so the camera ribbon will be able to move freely and not get twisted. No extra parts are needed if you're using a stock Anet A8. The backplate on this mount was made thin enough that it slides right over the back of the LCD backplate. Just remove three of the nuts, attach the mount, and replace the nuts. There are three models available. The top, the mount, and an stl with both pieces. There are no changes to the top from the original model, I only rotated it so it was ready to print.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Rear Pi mount for Anet A8 is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Chir.
- Who made this model?
- Designed by Chir, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Rear
