Low profile right angle cap for Neutrik XLR 5mm cable
Source: MakerWorld by killthrash
The Low profile right angle cap for Neutrik XLR 5mm cable is a free printable 3D model from MakerWorld by killthrash. Low profile right angle cap for Neutrik XLR 5mm cable This is a remix of hennedo's model to allow for a 5mm cable. You can download the STL file from the original listing below and print it at home.
About this model
Low profile right angle cap for Neutrik XLR 5mm cable This is a remix of hennedo's model to allow for a 5mm cable. I'm using a Neutrik NC4MXX-B Male 4-Pin XLR Cable Connector for a headphone cable and this remix cap fits perfectly for the Mogami W2893 cable. I route my headphone cable behind and under my desk, and this cap lets me tidy up the cable run while minimizing the footprint of my amp on my desk.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Low profile right angle cap for Neutrik XLR 5mm cable is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by killthrash.
- Who made this model?
- Designed by killthrash, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Low
