Is this 3D model free to download?

Yes, RepRack End Clamp is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by MakerWorld. Use the "Download from MakerWorld" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Roland Deschain, published on MakerWorld. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

RepRack End Clamp

Source: MakerWorld by Roland Deschain

The RepRack End Clamp is a free printable 3D model from MakerWorld by Roland Deschain. I designed this to ensure that my EMT was aligned correctly on both ends and to keep me from sticking my fingers into the sharp hole. Note: The picture is from an earlier version. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from MakerWorld

206 saves Source: MakerWorld Updated 2026-10-29 Print time: 56m Filament: 24 g License: CC-BY-SA · commercial OK ★ 4.9 (12) 104 makes Category: Home & Organization

Tags: filamentstorage, reprack

About this model

I designed this to ensure that my EMT was aligned correctly on both ends and to keep me from sticking my fingers into the sharp hole. Note: The picture is from an earlier version where the screw holes were blocked on the outside face also. My screws were just short enough that this was fine but yours might not be so I added the holes back.

Frequently asked questions

Is this 3D model free to download?: Yes. RepRack End Clamp is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
Where is the STL hosted?: The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by Roland Deschain.
Who made this model?: Designed by Roland Deschain, published on MakerWorld. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.