Polymaker / PolyTerra / Overture Spool Adapter
Source: MakerWorld by davidmakes
The Polymaker / PolyTerra / Overture Spool Adapter is a free printable 3D model from MakerWorld by davidmakes. This model still works great, but I there is an improved model that's quicker to print and is more compatible with the AMS Lite.AboutA ground-up rebuild of the excellent. You can download the STL file from the original listing below and print it at home.
About this model
This model still works great, but I there is an improved model that's quicker to print and is more compatible with the AMS Lite.AboutA ground-up rebuild of the excellent Polymaker spool adapter with the following changes:Edge clips removed (These tend to damage spools and are also not needed since the adapter uses the locator pin to lock into place)The Center design has been updated for a more generic spool look (More visually compatible with both Polymaker and Overture brands)The fitting has been slightly adjusted to allow easier swapping between spools without compromising its hold on the spool (less likely to break when being removed)PrintingPrints well in PLA and PETG. PETG is less brittle and has better layer adhesion, which is beneficial with the very thin edges (to help avoid layer …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Polymaker / PolyTerra / Overture Spool Adapter is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by davidmakes.
- Who made this model?
- Designed by davidmakes, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in spool
More from davidmakes
