Is this 3D model free to download?

Yes, IKEA SKÅDIS Pegboard to IKEA BROR Trolley Mounts is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by MakerWorld. Use the "Download from MakerWorld" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by evilspyboy, published on MakerWorld. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

IKEA SKÅDIS Pegboard to IKEA BROR Trolley Mounts 3D printable model by evilspyboy

IKEA SKÅDIS Pegboard to IKEA BROR Trolley Mounts

Source: MakerWorld by evilspyboy

The IKEA SKÅDIS Pegboard to IKEA BROR Trolley Mounts is a free printable 3D model from MakerWorld by evilspyboy. This is pretty simple, I needed a trolley to be able to get some tools out and move them around but I also had this spare IKEA pegboard. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from MakerWorld

134 saves Source: MakerWorld Updated 2026-09-27 Print time: 4h 23m Filament: 185 g License: CC-BY-NC · non-commercial ★ 4.8 (9) 72 makes Category: Office

Tags: ikea, rack, pegboard, skadis, trolley, toolrack, bror

About this model

This is pretty simple, I needed a trolley to be able to get some tools out and move them around but I also had this spare IKEA pegboard. A couple of iterations of 3D printed mounts I have combined the two like an IKEA Voltron if IKEA was just a body and one leg. Always room for improvement but the IKEA pegboard has slots more than holes so you have some room to move it a little. I used some 20mm M5 screws and have adjusted from my original design to give a little more room to tighten the nut + add the washer on the back. Im using 2 flat pieces and 2 top mounts but you can always add a couple more wherever you have your shelf for more support to spread the load if you are concerned about how much weight is on your pegboard (also if you noticed it bending at the top). You probably need suppo…

Frequently asked questions

Is this 3D model free to download?: Yes. IKEA SKÅDIS Pegboard to IKEA BROR Trolley Mounts is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
Where is the STL hosted?: The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by evilspyboy.
Who made this model?: Designed by evilspyboy, published on MakerWorld. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.