Is this 3D model free to download?

Yes, GAU-8 Gatling Barrel (A10 Warthog) is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by MakerWorld. Use the "Download from MakerWorld" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by viper2788, published on MakerWorld. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

GAU-8 Gatling Barrel (A10 Warthog) 3D printable model by viper2788

GAU-8 Gatling Barrel (A10 Warthog) photo 1

GAU-8 Gatling Barrel (A10 Warthog) photo 2

GAU-8 Gatling Barrel (A10 Warthog) photo 3

GAU-8 Gatling Barrel (A10 Warthog)

Source: MakerWorld by viper2788

The GAU-8 Gatling Barrel (A10 Warthog) is a free printable 3D model from MakerWorld by viper2788. This is a pen holder modeled after the A10 Warthog's GAU-8 Gatling gun. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from MakerWorld

474 saves Source: MakerWorld Updated 2026-10-13 Print time: 17h 26m Filament: 392 g License: SDFL · non-commercial ★ 4.9 (45) 334 makes Category: Home & Organization

Tags: warthog, gatling gun, pen holder, organizer, desktop, gau8, gun, gadget, navy, marine, army, military, northrup, grumman

About this model

This is a pen holder modeled after the A10 Warthog's GAU-8 Gatling gun. Measurements were carefully taken to be as dimensionally accurate as possible to the real thing. It's able to spin freely on a ball bearing shaft. Be sure to only use supports for plate #1 (Barrels/Heat Shield) - threads on other plates will print fine without support. Its also recommended to increase wall count to 3 for the shaft. A single 608 2RS (8mm x 22mm x 7mm) ball bearing is needed. It should press fit under the barrels. The shaft should also fit snug into the bearing - this part was made separate from the base for test prints (or easily replaceable if broken). If you run into fitment issues, increase or decrease the size of the entire shaft model by increments of 0.5% on the slicer until desired fitment is ach…

Frequently asked questions

Is this 3D model free to download?: Yes. GAU-8 Gatling Barrel (A10 Warthog) is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
Where is the STL hosted?: The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by viper2788.
Who made this model?: Designed by viper2788, published on MakerWorld. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.