Spinning Reel Display Stand
Source: MakerWorld by viper2788
The Spinning Reel Display Stand is a free printable 3D model from MakerWorld by viper2788. This display stand was designed to hold up to twelve spinning reels in various sizes. You can download the STL file from the original listing below and print it at home.
About this model
This display stand was designed to hold up to twelve spinning reels in various sizes. The largest reel shown in photos is a size 14000 (Daiwa), but should be able to accommodate bigger sizes. Spacing between the reels can be adjusted as necessary. The following hardware is needed in addition to printed parts. 1) 600mm T Slot 2020 Aluminum Beams (2 orders, total of 8 beams required) 50 T nuts included)These will need to be tapped/threaded to fit M6 bolts (M6x1.0) M6-1.0x22mm Bolts (16 required) Corresponding washers and nuts included.The bolts in the link are 22mm in length but shorter lengths can be used. Lock washers not necessary. M5-0.8x8mm Bolts (48 required) M5 Washers (48 required) reel foot support is recommended to be printed at 0.1mm layer height (or finer) to create a smooth ramp…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Spinning Reel Display Stand is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by viper2788.
- Who made this model?
- Designed by viper2788, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in spinning reel
