Is this 3D model free to download?

Yes, 3.5 Inch Display Stand and Cover is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Topo_Tron, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

3.5 Inch Display Stand and Cover 3D printable model by Topo_Tron

3.5 Inch Display Stand and Cover photo 1

3.5 Inch Display Stand and Cover photo 2

3.5 Inch Display Stand and Cover photo 3

3.5 Inch Display Stand and Cover

Source: Thingiverse by Topo_Tron

The 3.5 Inch Display Stand and Cover is a free printable 3D model from Thingiverse by Topo_Tron. The JC3248W535C 3.5" ESP32-S3 display from DIY Malls ships bare — no enclosure and no practical way to mount it. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-10-17 License: CC-BY-NC-SA · non-commercial 1 makes Category: Gadgets & Electronics

Tags: display stand, DIY-MALL, DIY-MALLS, esp32, esp32 case, JC3248W535C, smart home, smart home automation, Smart home control, smart home controller, stand, Touchscreen

About this model

The JC3248W535C 3.5" ESP32-S3 display from DIY Malls ships bare — no enclosure and no practical way to mount it. I built this to turn mine into a bedside smart home panel (lights, 3D printer smart switch, TV, air conditioner). What's included Full stand — the version I use daily. Angled foot, sits on a nightstand, screen tilted for comfortable reach. Back brace only — the same back plate without the foot. Aligning the screw holes and getting the bezel flush with the screen edges was by far the hardest part of this design, so this file exists so you can skip that and remix it into a wall mount, VESA plate, or whatever you need. Design notes USB-C port orientation: intentional. Mounting the display the other way puts the WiFi antenna at the bottom of the stand, and this board's antenna isn't…

Frequently asked questions

Is this 3D model free to download?: Yes. 3.5 Inch Display Stand and Cover is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Topo_Tron.
Who made this model?: Designed by Topo_Tron, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.